NEWS

September 30 2015

GN Solids Control already supplied more than 30 sets of drilling cuttings drying system to one of the largest service company in Nigeria and all of them working well and satisfied clients for long term cooperate . Normally it will contains vertical cuttings dryer , decanter centrifuge , screw pump , screw conveyor , work platform and or mud tank to make a complete system , but depending on drilling conditions and requirement , the clients may change design as per drilling site requirement .

20150930_DWM_1

Main Equipments For This African Client

3 sets of vertical cuttigns dryer which will be used to dry drilling cuttings out of shale shaker, desander and desilter . It is 30 to 50 tons per hour capacity with a 930 mm diameter tank body at 930 RPM rotating speed . Air knife installed to help avoid screen block by water base drilling cuttings . The air knife driven by one set of air compressor and one set of screw pump will be used to flush outlet of dryer to help fluids flow out successfully .

6 sets of variable speed decanter centrifuge to recycle drilling fluids separated by vertical cuttings dryer at 2 to 5 microns by 0 to 3200 RPM rotating speed . The decanter centrifuge is 360 mm bowl diameter and 1270 mm long bowl , there are tungsten carbide tiles bolted on screw impeller to help it working longer time and easy for replace tungsten carbide tiles . VFD control panel is designed to change centrifuge speed max to 3200 RPM depending on working conditions .

3 sets of feeding pump for decanter centrifuge to feed fluids into and 3 sets of pump for flush vertical cuttings dryer to help fluids flow out successfully . 15 sets of screw conveyor to transfer drilling cuttings amount different machine all cuttings box .